Working Mode; Test The Pir Motion Detector - Smanos X500 Manual Del Usuario

Working mode

Testing mode
After self-testing, press the test
button, the detector switches to the
testing mode and detects once
every 10 seconds. It triggers an
alarm. After 3 minutes, the LED
flashes twice, and the detector
switches to the power saving mode.
Power Saving mode
The product features power-saving design. If the detector detects human movement
twice in 3 minutes, it will switch to the sleeping state to save power. At this time, the LED
will not flash and no alarm. After no movement within the next 3 minutes, the detector
switches back to the working state automatically.
Case 1:
Initial start and then arm.
3 minutes later
Sleep after detecting human
movement twice
Switch from sleep to arm.
Note: After the detector is in the sleeping state, ensure no human movement within 3 minutes;
otherwise, the detector remains sleeping.
In the sleeping state, it is recommended that you leave the room after arming the system. Ensure no
human movement in 3 minutes. Then, go into the room, the system alarms immediately.
45
X500-UM-EN-IT-ES-PT-V1.0.indd 52-53
Case 2:
Press the test button and then arm.
No human movement
within 3 minutes

Test the PIR motion detector

This is to test whether the PIR detector works normally.
1. Remove the insulating strip 2. Arm the system
Remove the insulating strip.
Press the
control. The system is armed.
3. Trigger an alarm
Keep pressing the test button at the back until the control panel sounds. It indicates
that the PIR motion detector is connected to the control panel.
EN
[Arm ] button on the remote
46
2016/12/9 9:27:55