Starting Operation - Bosch GLI VariLED Professional Manual Original

Do not continue to press the On/Off switch after the worklight has been auto-
u
matically switched off. The battery can be damaged. Ensure that the battery is
charged and that the worklight has cooled before switching on the worklight again.
To remove the battery (4), press the release button (5) and pull the battery out of the
cordless worklight. Do not use force to do this.
Follow the instructions on correct disposal.
Operation

Starting Operation

Inserting the battery
Insert the charged battery (4) into lamp head (3) until it can be felt to engage and faces
flush against the lamp head.
Setting up
Place the cordless worklight on a stable, level surface. Make sure it is secure.
Switching On and Off
To switch on the cordless worklight, press the on/off switch (2).
To switch off the cordless worklight, press the on/off switch (2) again.
Temperature Dependent Overload Protection
If the permissible heat sink temperature of 60 °C is exceeded, the cordless worklight
flashes 3 times and switches off. Let the cordless worklight cool down and then switch
the cordless worklight back on.
Battery charge indicator
The green LEDs on the battery charge indicator indicate the state of charge of the bat-
tery. For safety reasons, it is only possible to check the state of charge when the power
tool is not in operation.
Press the button for the battery charge indicator or
This is also possible when the battery is removed.
If no LED lights up after pressing the button for the battery charge indicator, then the
battery is defective and must be replaced.
Bosch Power Tools
English | 17
to show the state of charge.
1 609 92A 636 | (11.12.2020)