Kohler K-4896 Instrucciones De Instalación página 3

S Apply a bead of sealant
around the base of bidet, and
carefully align the bidet inside
the outline drawn on the floor.
S Position bidet in the mounting
location so both floor bolts
extend through the bidet side
mounting holes.
S Assemble the bolt cap bases,
washers, and nuts.
Hand-tighten nuts, then tighten
them an additional 1/2-turn with
wrench.
CAUTION: Risk of personal
injury or product damage.
Vitreous china can chip or
break easily if the nuts are
overtightened or the product
is handled carelessly.
S If floor bolts extend more than
1/4" (6mm) from top of nut,
loosen nut and turn bolt further
into floor. Retighten nuts, and
install bolt caps.
START-UP
S Connect the water supplies
and drain.
S Turn on the hot and cold
shut-off valves. Check the
entire installation for leaks.
Repair as required.
S Check all connections for
leaks for several days.
Kohler Co., Kohler, WI U.S.A.
Bolt Cap
Nut
Washer
Bolt Cap
Base
T-Bolt
Bead Of
Sealant
1010408-2-
3
A