To Start The Product; To Fill The Fuel Tank - Husqvarna 525BX Manual De Usuario

1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.

To fill the fuel tank

WARNING: Obey the procedure that follows
for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
1436 - 001 - 09.03.2020
Note: To see where the fuel tank is on your product,
Introduction on page 2 .
refer to

To start the product

1. Move the throttle control to the idle position.
2. If the engine is cold push the choke control to the
closed choke position.
3. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary to
fill the air purge bulb fully.
4. Put the product on a flat surface on the ground.
5. Hold the product with the right hand.
CAUTION: Do not use your feet to hold
the product.
6. Pull the starter rope handle slowly until resistance
occurs.
7