Fitting Advice - Blatchford AK30M1 Instrucciones De Uso

7 Fitting Advice

The instructions in this section are for practitioner use only.
Position as close as practical to the build line.
Set Screws
4
15 Nm
Symptom
A recurring noise occurs at the device
interfaces.
The adapter moves out of position.
Solution
Check security of all alignment screws and
tube clamp. Apply Loctite as required and
tighten to correct torque settings. Ensure
mating surfaces are clean and end of tube is
cut square.
User must not use the device until adjusted,
repaired or replaced.
8
Clamp Screw
4
10 Nm
938252PK1/1-0121