Troubleshooting - GreenWorks GWSN20130 Manual Del Propietário

TROUBLESHOOTING

PROBLEM
The handle is not in
position.
The snow thrower does
not start.
The motor is on, but the
impeller does not turn.
The snow thrower
leaves a thin layer of
snow behind.
POSSIBLE CAUSE
The bolts are not properly
seated.
The switch is defective.
The extension cord is not
connected to the plug.
The extension cord is not
connected to the power
source.
The belt is damaged.
The scraper is worn.
SOLUTION
Make sure the bolts are correctly installed
through the handle bars. Check to see if the
hand knobs are tight. Refer to Assembling
the Handle section in this manual.
Have the switch replaced by an authorized
service center.
Connect the plug on the snow thrower to the
extension cord.
Plug the extension cord into a live 120 V
AC, 60 Hz outlet.
Replace the belt (see the section entitled
Replacing the Drive Belt).
Inspect the scraper for wear or damage.
Replace the scraper (see the section
entitled Replacing the Scraper).
24