Clock; Clock Reception; Manually Set Clock - Oregon Scientific EasyPlus EC101 Manual Do Usuário

NOTE
• Make sure the adaptor is not obstructed and is easily
accessible to the unit.
• To completely disconnect from power, the adaptor
should be disconnected from the mains.
• The main unit and adaptor should not be exposed to
wet conditions. No objects filled with liquid, such as
vases, should be placed on the main unit and adaptor.
Insert batteries (for memory back-up only):
1. Remove the battery compartment cover.
2. Insert the batteries, matching the polarities.
NOTE Batteries should not be exposed to excessive heat
such as sunshine or fire.

CLOCK

CLOCK RECEPTION

Once connected to a power source, the clock will
automatically start scanning for the radio-controlled time
signal.
To search for signal reception: Press RCC.
Reception takes 2-10 minutes. If the signal is weak, it can
take up to 24 hours to get a valid signal.
Clock reception indicator
No signal
In some cases, you may not receive the signal immediately.
Due to the atmospheric disturbance, the best reception
often occurs at night.
If signal reception is unsuccessful, place your unit next to
a window, press RCC to attempt another signal search.
Manually forcing another signal search will consume more
battery power.
Daylight savings time (DST)
The clock has been programmed to automatically switch
when daylight savings time is in effect.

MANUALLY SET CLOCK

If located outside the radio signal range, you can manually
set the clock.
NOTE Once clock is within range and receives radio signal,
clock will automatically synchronise and replace the time /
date that was set manually.
4
weak signal Strong ignal