Cleaning And Maintenance; Accessories And Replacement Parts; What If There Are Problems; Disposal - Beurer FC 90 Instrucciones Para El Uso

• After one minute of treatment, press the cool button
30 seconds. "WAITING" is shown in the display. As soon as the "WAITING" display turns off, the device
is ready to use. Continue with the treatment for another minute.
• Repeat this heat and cool treatment as described above for one minute each. If necessary, apply a little
more Advanced Hydro Lift Cream.
• To switch the device off again, press the ON/OFF button

8. Cleaning and maintenance

• When you are not using the device, store it in a cool, dry place away from direct light.
• Carefully clean the device after every use with a cleaning cloth. If necessary, use a slightly damp cloth.
Ensure that no water gets inside the device while cleaning it.
• Do not use any cleaning agents or solvents, as they could damage the device.
• Under no circumstances should you hold the device under water, as this can cause liquid to enter and
damage the device.

9. Accessories and replacement parts

For replacement parts and additional items visit www.beurer.com or contact the corresponding service
address in your country (according to the service address list).
Replacement parts and additional items are also available from retailers.
Item
Advanced Hydro Lift Cream (30 ml)
Intensive Cleansing Milk (200 ml)

10. What if there are problems?

Problem
There is nothing shown in the
device display.
The heat and cool function is
not working.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful
life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in
accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have
any questions, please contact the local authorities responsible for waste disposal.
Item number and/or order number
163.392
163.394
Cause
The mains adapter is not
plugged in correctly.
The device is not switched on.
The mains cable is damaged.
The device is damaged
15
. The device is now in the precooling phase for
.
Solution
Check that the mains adapter is
correctly plugged in.
Press the ON/OFF button.
Contact your retailer.