Inside Mount - Levolor Natural Shades Instalación

INSIDE MOUNT (IM)
For shallow mount, insert
screw in the upper rear
corner of the bracket
STEP 1: MARKING THE BRACKET LOCATIONS
NOTE: Before marking bracket locations, ensure that your bracket placement will not
interfere with any components inside the headrail.
• Mark 2" in from each jamb for bracket location.
— If more than two installation brackets came with your order, space additional
bracket(s) evenly between the two end brackets.
— Allow a minimum of 18" from the motor side of the headrail and 15" between
the brackets to accomodate the Standard Battery Pack. Mount into wood
whenever possible.
2"
Jamb
• Center the brackets on your marks, then mark each of the screw holes.
— Mounting depths vary depending on the power option. See the chart page 3
for minimum and fully recessed depth requirements.
— Use the center screw hole when depth permits.
— For shallow mounting depths, use the hole located in the upper
rear corner of the bracket.
— Mark their location.
Bracket
Bracket
Space Evenly
Window Side
Minimum of 15" for Battery Wand
Space Evenly
Room Side
Battery-Powered Motorized Operating System
INSTALLATION
2"
Jamb
9