Installation; Inside Mount - Levolor Roman Shades Instalación

INSTALLATION

INSIDE MOUNT (IM)
Bracket
Bracket
STEP 1: MARK THE BRACKET LOCATIONS
IMPORTANT: Before marking bracket locations, ensure that your bracket
placement will not interfere with any components inside the headrail.
•
Verify that your window casing has a minimum depth of ½" which allows for a
partially recessed headrail mount.
•
If flush mount (fully recessed mount) is desired, a minimum mounting depth of
2 ⁄ " is required.
1
8
•
Mark 1 - 2" from each jamb for bracket location.
•
With a pencil, mark the longer, oblong drill hole locations through the top of the
holes of the bracket, 2 holes per bracket.
•
If more than two installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets, no more than 30" apart, and
mark drill hole locations.
8
Cordless Lift Control
19-0050-030 Romans Install Guide-Cordless_F_070720.indd 8-9
INSIDE MOUNT (IM)
Bracket
Bracket
Screw
Screw
STEP 2: INSTALL THE BRACKETS
•
Pre-drill screw holes using a ⁄ " drill bit (wood and metal mounting surfaces only)
1
16
using pencil marks as a guide.
•
Hold the bracket with the surface marked "Top" facing up. Line up the pre-drilled
screw holes and the longer, oblong holes in the bracket.
•
While holding the bracket in place, secure the bracket with screws, 2 screws
per bracket.
•
Repeat for each bracket.
•
Ensure all brackets are square with each other.
INSTALLATION
9
Cordless Lift Control
7/7/20 9:11 AM