Turn Radio-Controlled Clock On / Off - Oregon Scientific BAR926HG Manual Del Usuario

Initial reception takes 2-10 minutes, and is initiated when
you first set up the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking.
In addition to the local time and calendar display, you
can also select to display the corresponding time of 130
major world cities.
The icon shown in the Clock Area indicates 2
factors:
• Connection between the main unit and the sensor
that collects RF signals (
• RF signal reception (
How these signals work together:
MEANING
ICON
The unit has contact with the
sensor and has synchronized
the time.
The unit has contact with the
sensor but the time has not been
synchronized.
The unit has lost contact with
the remote sensor but the time
is synchronized.
The unit has lost contact with the
remote sensor and the time is not
synchronized.
)
)
NOTE To force a manual search for RF clock reception,
press and hold SEARCH on the sensor (RTGR328N)
for 2 seconds.

TURN RADIO-CONTROLLED CLOCK ON / OFF

If you wish to manually set the clock, you must first
disable the radio-controlled feature. To do this, navigate
to the Clock / Alarm Area. Then, press and hold
the main unit for 2 seconds. To enable it, navigate to
the Clock / Alarm Area, then press and hold
seconds.
RF clock enabled:
RF clock disabled:
13
The unit cannot reach the remote
sensor.
on
for 2