Oregon Scientific BAR321 Manual Del Usuario página 9

GETTING STARTED
BATTERIES
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
To open the battery compartment:
1. Insert a coin in the slot. Gently press back until
the battery compartment pops out of place.
2. Grasp the battery compartment by the sides and
gently pull to open. It will not completely detach
from the main unit.
NOTE
Do not use rechargeable batteries.
shows when batteries are low.
UNIT
Main
Remote
UV Sensor
LOCATION
Calendar Area
Humidity Area
UVI / Barometric
Measurement Area
AC ADAPTER ( MAIN UNIT )
The AC power adapter socket is located inside the
battery compartment of the main unit. Batteries are for
back-up purposes only; adapter is required for Audio
Broadcast.
To plug in the AC Adapter:
1. Open the battery compartment.
2. Plug the jack in the power socket.
3. Wrap the power cord under the prongs to guide it
out of the battery compartment.
4. Close the battery compartment.
5. Plug the other end of the Adapter into a wall socket
to power it on.
shows in the UVI / Barometric Measurement
Area when AC adapter is not plugged in.
8