HoMedics BPA-050 Manual De Instrucciones página 11

1. Press the User Select Button to choose User 1 or User 2.
MEM
START
After the user number is selected, press the
STOP
START/STOP button to confirm the chosen user.
2. With the cuff wrapped around your arm, press the
START/STOP button. Do not inflate the cuff unless it
is wrapped around your arm. All digits will light up to
check the display functions. The checking procedure
will be completed after about 2 seconds.
MEM
START
STOP
3. After all symbols disappear, the display will show a
blinking "0". The monitor is "Ready to Measure"
and will automatically inflate the cuff to start
measurement.
OR
19
4. Once your systolic pressure is determined, the monitor will
begin deflating to measure your diastolic pressure.
Note: This monitor will re-inflate automatically if the system detects that
your body requires more pressure for measurement.
5. When the measurement is completed, the cuff
will deflate. Systolic pressure, diastolic pressure
and pulse will be shown simultaneously on the
LCD screen. The measurement
is then automatically stored
into memory.
Note: 1. This monitor automatically turns off approximately 1 minute after last
operation. You may also press the START/STOP button to turn the unit
off.
2. To interrupt the measurement, you may press the START/STOP (rec-
ommended), "MEM", User-Select or Date/Time Set
The cuff will deflate immediately after a button is pressed.
buttons.
20