Wiring; Commissioning; Pre-Programming The Rts; Control Point - SOMFY HOME MOTION Oximo 50 S auto RTS Manual Del Usuario

Installation guide
Insert the connector (K) of the
2)
Oximo RTS module (E) into the S tubular
module (D).
Screw the connector (K) into the S tubular
module (D).
Fit the tube complete with S tubular module (D)
3)
to the motor bracket (L).
Fit the stop ring (M).

5. Wiring

Turn off the power supply.
1)
Connect the Oximo 50 S auto RTS motor accor-
2)
ding to the information in the table below:
230V/50 Hz ~
a Brown
b Blue
c Yellow/Green

6. Commissioning

To commission the motor, an RTS control point must
be programmed.
Caution! Only one S tubular module and one Oximo
RTS module must be powered at the same time.
Caution! Do not use the Inis RT/Inis RTS control
point for commissioning.

6.1 Pre-programming the RTS

control point

Switch on the power supply.
1)
Simultaneously press the Up/Down buttons on the
2)
RTS control point:
The roller shutter makes an up and down
movement, the control point has been pre-
programmed in the motor.
Copyright © 2008 Somfy SAS. All rights reserved.
Wire
Live (P)
Neutral (N)
Earth ( )
Oximo 50 S auto RTS
2
D
E
K
3
M
L
OFF
1
2
a
230 V
50 Hz
b
~
c
1 2
ON
D
a
b
c
55