Adding/Deleting Rts Sensors; Modifying The Direction Of Rotation; Use And Operating Mode; Standard Operation - SOMFY HOME MOTION Oximo 50 S auto RTS Manual Del Usuario

Oximo 50 S auto RTS

7.3 Adding/Deleting RTS sensors

Activate the favourite position, see the section
-
entitled "Activating the favourite position". This
enables the sensor to be used.
Find an RTS control point (K) programmed in the
-
Oximo 50 S auto RTS motor.
Press and hold the PROG button on the program-
1)
med RTS control point (K) until the roller shutter
moves up and down:
The Oximo 50 S auto RTS motor is in
programming mode.
Briefly press the PROG button on the RTS
2)
sensor (N) to be added or deleted:
The roller shutter moves up and down,
The RTS sensor (N) is programmed into
or deleted from the Oximo 50 S auto RTS
motor.

7.4 Modifying the direction of rotation

Caution! Any modification to the installation (remo-
ving the connections or bolts, removing the S tubu-
lar module from the roller tube, etc.) requires the
original Oximo 50 S auto RTS motor settings to be
restored and complete installation of the Oximo 50
S auto RTS motor to be carried out again as set out
in the section entitled "Installation".
The direction of rotation may be modified at any
time:
Place the roller shutter in any position: the roller
1)
shutter does not need to be in the upper or lower
end limit position.
Press the up and down buttons until the roller
2)
shutter moves up and down.
Press the STOP/my button until the roller shutter
3)
moves up and down:
The direction of rotation has been modified.
Press the up button to check the new direction
4)
of rotation.

8. Use and operating mode

8.1 Standard operation

8.1.1 Activating the favourite position
Carry out 2 complete roller shutter up and down
-
cycles up to the upper and lower end limits to
activate the favourite position.
58
Adding
1
PROG.
Deletion
1
PROG.
1
3
Copyright © 2008 Somfy SAS. All rights reserved.
Installation guide
2
PROG.
K
N
N
2
PROG.
K
N
2
4
N
N