General Information - Uline H-35 Manual Del Usuario

BEFORE USING THE MACHINE
After removing the machine from the carton, check the
following items before storing the shipping cartons:
• Brush Tank and two Moistening Brushes: These are
packed inside the rear of the machine.
• Plastic Water Bottle: This is packed on the side of the
dispenser.
HEATER SETUP (FOR H-669 ONLY)
1. Locate the heater kit box.
2. Remove retaining ring. (See Figure 2)
Figure 2
Retaining
Ring
3. Remove shaft and gold rollers and set aside.
4. Install heater shaft with silver rollers from spare parts
bag. (See Figure 3)
Figure 3
Shaft
5. Use replacement retaining ring provided to hold the
shaft in place.
6. Direct the heater cord under the bottle bracket. Place
cord clamp on heater cord and, using screw and nut
provided, fasten to existing hole. (See Figure 4)
NOTE: Make sure there is enough slack in the
cord near the heater so the heater assembly
can pivot freely up and down.
PAGE 2 OF 15

GENERAL INFORMATION

•
SETUP
SETUP
1.
With the slot towards the front of the machine, slide feed
wheel shaft under from rear until the cut-out portions
are over the retaining buttons. Allow the plate to slide in
place so that the front end of the plate is under the rod,
and the rear portion is under the buttons. (See Figure 5)
2. Wash out the moistening brushes in soap or mild
Upper Tape Plate: This is
held in position by packing
material, but may have
become dislodged in
shipping. Remove tape, etc.
before using the machine.
(See Figure 1)
Figure 4
Bottle
Bracket
If the upper tape plate has been dislodged in
shipping, replace as follows:
Retaining
Buttons
Feed
Wheel
Shaft
Rod
detergent and place both brushes into the tank so
the angle on the brushes slopes toward the rear of
the tank. (See Figure 6)
Figure 6
Figure 1
Cord
Clamp
Figure 5
0521 IH-35