Installation; Maintenance & Servicing; Environmental Conditions - OHAUS STLC1DG Manual De Instrucciones

i
nsTallaTion
Upon receiving the Ohaus Large Capacity Stirrer, check to ensure that no damage
has occurred in shipment. It is important that any damage that occurred in transport
is detected at the time of unpacking. If you do find such damage the carrier must be
notified immediately.
After unpacking, it requires two (2) people to lift the Large Capacity Stirrer, from the
bottom of the unit, to place on a level bench, table or floor, away from explosive
vapors. Ensure that the surface on which the unit is placed will withstand typical heat
produced by the unit. Always place the unit on a sturdy work surface.
The Large Capacity Stirrer is supplied with a power cord that is inserted into the
IEC connector on the left side of the unit first, then it can be plugged into a properly
grounded outlet. The 120V unit plugs into a 120 volt, 50/60 Hz source.
m & s
ainTenanCe erviCing
The Large Capacity Stirrer is built for long, trouble-free, dependable service.
No lubrication or other technical user maintenance is required. It needs no user
maintenance beyond keeping the surfaces clean. The unit should be given the care
normally required for any electrical appliance. Avoid wetting or unnecessary exposure
to fumes. Spills should be removed promptly. Do not use a cleaning agent or solvent
on the front panel or top plate which is abrasive or harmful to plastics, nor one which
is flammable. Always ensure the power is disconnected from the unit prior to any
cleaning. If the unit ever requires service, contact your Ohaus representative.
e C
nvironmenTal onDiTions
Operating Conditions: Indoor use only.
Temperature: 5 to 40°C (41 to 104°F)
Humidity: 20% to 80% relative humidity, non-condensing
Altitude: 0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: 20% to 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
e D
quiPmenT isPosal
This equipment must not be disposed of with unsorted waste. It is your responsibility
to correctly dispose of the equipment at life-cycle-end by handing it over
to an authorized facility for separate collection and recycling. It is also
your responsibility to decontaminate the equipment in case of biological,
chemical and/or radiological contamination, so as to protect the persons
involved in the disposal and recycling of the equipment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure that
your equipment is recycled in a manner that protects human health.`
2