Test Printing - Epson TM-S2000MJ Manual Del Usuario

English
❏
To transport or store this product for a long period after once using this product,
make sure the ink cartridge is installed in the product.
❏
This printer may automatically run maintenance operations at night or when the
power is turned on to maintain print quality. As a result of these maintenance
operations, you may need to replace the ink cartridge. In this case, replace the ink
cartridge with a new one.
Installing and Replacing the Ink Cartridge
When ink is low in the ink cartridge, the Ink LED flashes. When the Ink LED as well as the
Error LED come on, printing stops and it is time to change the ink cartridge.
Follow the steps below to install the ink cartridge into the product for the first time or
replace it with a new one.
1. Turn on the product.
2. Put your finger under the left side of the ink cartridge cover and pull it up to open it.
(See illustration C.)
3. If there is a used ink cartridge, remove the ink cartridge by pulling up the tab on the
top of the cartridge while holding the product. (See illustration D.)
4. Remove a new ink cartridge from its package.
5. Install the ink cartridge in the correct direction, and push it until it clicks in place.
6. Close the ink cartridge cover.
Note:
When you first use the product, installing an ink cartridge begins charging the ink
supply. Ink charging takes approximately four minutes and
during that time. Do not tilt the product during ink charging to avoid ink leakage.
Be sure not to turn off the product or open the covers while
flashing. This restarts the ink charging, which wastes ink.
7. Make sure

Test Printing

After the product setup or when the product is not operating correctly, you can check the
product operation with test printing. If the product performs pattern printing when you
follow the steps below, the product is operating normally.
Note:
For test printing on cut sheet paper, use the included cut sheet paper (normal paper of 70
mm {2.76"} width and 152 mm {5.98"} long or larger).
Do not use thermal roll paper.
Make sure all the covers are closed, and while pressing the cleaning button, turn on the
product. After the Document LED flashes, set 3 pieces of cut sheet paper in the ASF. (For
how to set the cut sheet paper, see "Inserting Cut Sheet Paper" on page 16.)
Test printing is completed when "*** completed***" is printed after a certain amount of
printing.
14 TM-S2000MJ User's Manual
(Power) LED turns on after flashing.
(Power) LED flashes
(Power) LED is