Setting Up The Product; Installing The Product; Connecting The Usb Cable - Epson TM-S2000MJ Manual Del Usuario

English

Setting up the Product

To set up the product, follow the steps below.
1. Unpacking (See "Unpacking" on page 12.)
2. Installing the product (See "Installing the Product" on page 12.)
3. Connecting the USB cable (See "Connecting the USB Cable" on page 12.)
4. Connecting the AC adapter (See "Connecting the AC Adapter" on page 13.)
5. Turning on the product (See "Tuning on/off the Printer" on page 13.)
6. Installing the ink cartridge (See "Installing and Replacing the Ink Cartridge" on
page 13.)
7. Operation check with test print (See "Test Printing" on page 14.)
Unpacking
Check whether the following items are included. If any item is damaged, contact your
dealer.
❏
TM-S2000MJ
❏
USB cable
❏
AC cable
❏
User's manual (this manual)
*1: May not be included depending on the product model.

Installing the Product

When installing the product, make sure of the following:
❏
Leave enough space around the product to open the covers, the ASF tray, and the
pocket guide.
❏
Do not place the product near any magnetic fields to avoid decreasing the MICR
recognition rate. Especially, when you install the product near a display device, check
the recognition rate of the MICR reader.
❏
Install the product horizontally.
❏
Make sure cords and foreign objects are not caught in the product.
❏
Remove the shock-absorbing materials in the product and fixing tape before use.

Connecting the USB Cable

Note:
Do not turn on the product before installing the necessary drivers.
1. Connect the USB cable to the USB (Type B) connector. (See illustration A.)
2. Fix the USB cable with the cable hook to prevent the USB cable from falling off. (See
illustration A.)
3. Connect the USB cable to the host computer.
12 TM-S2000MJ User's Manual
*1
❑
Dedicated ink cartridge [SJIC18(K)] x 2
❑
AC adapter [PS-180 (Model: M159B)]
❑
Cut sheet paper for test printing
❑
Setup guide