Cleaning The Print Head - Epson TM-S2000MJ Manual Del Usuario

2. Put the ID card in the insertion slot on the right side of the pocket with its photo side
facing the pocket, and slide it along the bottom of the slot. (See illustration H.)
3. When the card starts feeding, release it immediately.
CAUTION:
When the ID card is feeding, a part of it comes out of the card carrier slit at the back of the
product. Be sure not to block this slit.
Do not touch the ID card when it is being ejected. Doing so may cause distortion and other
problems with the scanned data.
Do not open the covers while processing is in progress.
4. When the ID card is ejected and the ID Card LED flashes, remove the ID card from the
slot.
Reading Magnetic Stripe Cards
If your product is equipped with a MSR unit, you can read the magnetic stripe on the card.
Note:
Use a magnetic stripe card which meets the specifications. (See "Specifications" at the
beginning of this manual.)
To read the magnetic stripe card, check the insertion direction with the arrow on the card,
and swipe it through the slit downward or upward with the magnetic stripe on the card
facing inside and down. (See illustration I.)
The buzzer beeps once when reading succeeds and beeps three times when it fails.
Cleaning
Cleaning the Product Case
Be sure to turn off the product, and wipe the dirt off the product case with a dry cloth or a
damp cloth.
CAUTION:
Never clean the product with alcohol, benzine, thinner, or other such solvents. Doing so may
damage or break the parts made of plastic and rubber.

Cleaning the Print Head

When printing becomes faint or uneven although the Ink LED is not on or flashing, the
print head may need to be cleaned.
In this case, press the cleaning button on the control panel for 3 seconds or more to start
the print head cleaning. During the cleaning,
When
(Power) LED comes on after flashing, the print head cleaning is completed.
Note:
The cleaning process uses some ink. Do not run cleaning when it is unnecessary.
(Power) LED flashes.
TM-S2000MJ User's Manual 17
English