Tabla de contenido
Publicidad
Chapter
05
Changes on the upgraded programme
Connecting and
disconnecting an iPod
CAUTION
! To prevent data loss and damage to the sto-
rage device, never remove it from this naviga-
tion system while data is being transferred.
! Pioneer cannot guarantee compatibility with
all USB mass storage devices and assumes
no responsibility for any loss of data on media
players, iPhone, smartphone, or other devices
while using this product.
Connecting your iPod
1
Check that no USB storage device is
connected.
2
Connect your iPod.
Lightning Digital AV Adapter
HDMI/USB interface
cable for iPod /
iPhone
= For details of the operations, refer to the lat-
est Installation Manual.
The latest manual is available on our web-
site.
http://www.pioneer-car.eu
24
Engb
Disconnecting your iPod
% Pull out the cables after confirming
that no data is being accessed.
Using an iPod (iPod)
Starting procedure
1
pin Connector".
2
screen is displayed.
3
The source changes and then playback will
start.
4
to control your iPod.
Lightning to USB
cable
Using Aha Radio
Starting procedure
The procedure varies depending on the type of
device.
Set "iPod Connection Settings" to "30-
= For details, refer to Selecting the device con-
nection method on page 27.
= For details, refer to Setting the iPod connec-
tion on page 28.
Press the MODE button when the map
p The AV operation screen can also be dis-
played by touching [AV Source] on the
"Top Menu".
Connect your iPod.
= For details, refer to Connecting your iPod on
page 24.
p If the iPod is already connected, touch
[iPod] on the left edge of the screen.
p If connecting an iPhone or iPod touch, quit
applications before connecting.
Use the touch panel keys on the screen
p The video image of the iPod may have noise
if the rear display outputs the video image.
When noise is produced in the video image
of the iPod, turn off the output setting of the
rear display.
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
