Tools Required - MTD 490-241-0032 Instrucciones De Montaje

Tools Required:

3/8, " 9/16" and 1/2" box wrenches (not included);
Allen wrench (included).
CAUTION: WEARING SAFETY GLASSES IS RECOMMENDED DURING ASSEMBLY.
Assistance from another person is recommended for certain steps.
Refer to parts identi cation sheet to ensure you have all necessary parts.
Assembly Instructions:
1. Lay sets of bars A & B on a fl at surface. Slide A & B
all the way together. Wait until the entire frame is
assembled before completely tightening set screw (S)
with the enclosed Allen wrench. Insert set screw (S) into
the end of bar B, securing fi nger-tight. Repeat with
other set of bars A & B.
2. Attach bar E to the B end of the A/B assemblies.
Insert set screw (S), securing in fi nger-tight at the end
of bars B where arrows point. Make sure nuts on
bar E face assemblies A/B.
3. Insert poles F, narrow end up, into the union of
bars E, A & B.
2
2
3/8" 1/2"
A
Notice orientation of bar B
B
A
B
A
9/16"
B
Set Screw (S)
E
B
A
F
F
E
B
A