Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: For steps 8, 9 & 10, please be sure
NOTE: You should have four H rods and one I rod.
8.
Pull the cover out of box and locate the inside sleeves. Feed one
H rod through one sleeve of the cover, then repeat with another H rod on
the other side. Insert the steel collar ends of these H rods into the tops of
poles F. The cover will be hanging
loosely on the rod/pole assembly.
NOTE: Flexible H rods will feel loose
when inserted. This is correct.
Do not attempt to force exible
H rods further into poles F.
9.
Slide the two remaining H rods over the previously
inserted H rods. Take rod I and insert the ends of the H rods
into the steel collar ends of rod I. Pull the cover up over the rod
assembly and slide the top of the assembly into the large pocket
inside the cover. This will require some bending of the rods.
H
Steel Collar
I
H
H
10.
Pull the cab material down and back towards the
arch assembly, D/C/D. Fasten hook-and-loop straps on both
sides of the D/C/D assembly. Slide elastic loops over the rear
corner of bar A on both sides. Fasten hook-and-loop straps
around all bars at various locations. (For your convenience
you may want to wait until the cab is mounted on your snow
thrower to finish fastening these straps.)
4
4
you wear safety glasses.
I
Steel Collar
H
H
H
H
H
H
F
F
Insert fl exible rod
assembly here
C
D
Fabric pocket
Safety Glasses
H
Sleeve
I
H
H
Front
Back
Front
A
A
Back
D
Publicidad
