Publicidad
Idiomas disponibles
Idiomas disponibles
4. Insert poles G, narrow end up, into A end of both A/B
assemblies. Insert set screw (S) into top of bars A,
securing in fi nger-tight.
5. Place curved bar C on fl at surface, nuts facing up.
Insert the labeled end of curved bar D into C (making
sure arrows meet). Repeat with the other bar D on the
opposite end of bar C. Insert set screw (S) into ends of
bars C, securing in fi nger-tight.
6. Place assembly D/C/D onto ends of poles G. Insert
set screw (S) at top of poles G, securing in fi nger-tight.
NOTE: Make sure set screws are facing towards
the front.
7. Make sure cab frame is in the shape of a box, with
right angles. Then tighten all the set screw (S), using
the enclosed Allen wrench.
F
Front
B
G
G
A
Back
D
C
C
D
F
G
B
Back
F
E
B
A
D
D
Front
F
E
B
G
3
3
Publicidad
