Publicidad
Idiomas disponibles
Idiomas disponibles
17. Fully insert the ends of the front of the cab assembly
into the ends of the crossbar (J). Insert set screws (S)
into ends of crossbar (J). With assistant holding cab
assembly horizontal to the ground, tighten all bolts and
set screws.
18. Finish assembly by fastening all hook-and-loop straps
inside the cab if you have not already done so.
CAUTION: No cab fabric should be allowed to touch engine
or exhaust.
19. Using hook-and-loop straps, secure convenient pouch
on the inside of your snow thrower cab.
20. The cab is designed to accommodate snow throwers
equipped with a light. Zippers on the front of the cab
can be opened and the fl aps pulled back and secured
with hook-and-loop straps to allow the light to shine
through. At this time, adjustments may be necessary
for free movement of operation controls.
J
7
7
Publicidad
