Extra Weight - Stihl MM 56 Manual De Instrucciones

English
Other Hints on Starting
Engine stalls in cold start position g or
under acceleration.
Move the choke knob to < and
N
continue cranking until the engine
runs.
Engine does not start in warm start
position <
Move the choke knob to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Engine is flooded
Move the choke knob to F and
N
continue cranking until the engine
runs.
Fuel tank run until completely dry
After refueling, depress the manual
N
fuel pump bulb at least five times –
even if the bulb is already filled with
fuel.
Set the choke knob to suit the
N
engine temperature.
Now start the engine.
N
14

Extra weight

To increase the weight on the MultiTool,
the MultiEngine can be retrofitted with
an additional weight (special
accessory).
Always use original STIHL additional
weight. Using other weights can lead to
damage to the machine and personal
injuries.
Attaching additional weight
No wheels are attached to the
MultiEngine
Use the combination wrench to loosen
and tighten the weights.
Detach the weights on the side without
the square – to do this:
1 2 5
The weights (1) on the side with the
square (2) remain mounted on the bolt.
Unscrew the hexagon head bolt (3)
N
and remove the outer weight (4)
Detach the inner weight (5) and
N
remove it from the bolt
1 2
Push additional weight (1) with bolt
N
through the hole (6) in the flange; in
the process, rotate it until the
square (2) engages in the opening
in the flange
Turn the inner weight (5) onto the
N
bolt and tighten
Fasten outer weight (4) with the
N
hexagon head bolt (3) in the thread
of the inner weight and tighten
One or two weights can be mounted on
each side of the additional weight as
needed.
Weights on
each side
1
2
4 3
NOTICE
The maximum additional weight is
8.8 lbs. (4 kg). Never use higher
additional weight. This can cause
damage to the machine.
Wheels are attached to the MultiEngine
If wheels (special accessory) – see
"Wheels" – are already attached to the
MultiEngine, then additional parts are
required in order to install the additional
weight.
4 3
6 5
Additional weight,
total
4.4 lbs. (2 kg)
8.8 lbs. (4 kg)
MM 56 C