Stihl MM 56 Manual De Instrucciones página 8

English
WARNING
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
WARNING
To reduce the risk of injury from a
MultiTool rotating in the wrong direction,
check that the position of the gearbox is
correct and change it if necessary.
On metal tools (top illustration), position
the gearbox so that the shaft is below
the drive tube.
6
Use for:
BF-MM cultivator blades with
–
pointed tines
BK-MM cultivator blades with
–
curved tines
FC-MM edger
–
RL-MM aerator
–
MF-MM dethatcher
–
On sweeping tools (bottom illustration),
position the gearbox so that the shaft is
above the drive tube.
Use for:
KB-MM bristle brush
–
KW-MM STIHL PowerSweep
–
For tools used to cut grass, trim and
prune, remove the gearbox.
Use for:
FS-MM brushcutter
–
Check the instruction manual for the
MultiTool to ensure you are using the
appropriate deflector for that MultiTool.
Starting
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your MultiEngine
and MultiTool manuals.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
WARNING
Always stand to one side of the unit to
avoid the risk of injury from contact with
the rotating working tool.
WARNING
To reduce the risk of
injury from loss of control,
be absolutely sure that
the working tool is clear
of you and all other
obstructions and objects,
including the ground,
because when the engine
starts at starting-throttle,
engine speed will be fast
enough for the clutch to
engage and move the
working tool.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
MM 56 C