Tylo CC20 Instrucciones De Instalación página 5

Press ON – the timer is activated and the time indicator flashes during the
pre-set time period. Once the heater switches on, it remains on for 3 hours,
after which it automatically switches off. If you want to switch it off earlier, just
press OFF. To extend your bathing time, press ON. The LED for the desired
type of bath should be lit.
Main power switch.
At the bottom of the relay box, SE heater and the smaller steam generator
types, there is a main power switch that should only be used if the sauna is
not to be in use for an extended period, such as several weeks. Note: The
memory function must be reset each time the power has been interrupted.
TYLARIUM
The Tylarium offers sauna bathing in all its forms: dry sauna, wet sauna and
steam baths. Since the relative humidity sometimes is higher than in a
traditional sauna bath, please observe the following recommendations.
• If the sauna has a window in the door or wall, treat the entire lower
moulding with boat varnish and seal the joint between the glass and the
moulding with a water-resistant silicone sealant. This prevents any
condensation on the glass from seeping into the joint.
• Varnish the threshold and door handles a few times with boat varnish to
maintain the finish and simplify cleaning the sauna. Benches, decorative
edging and back supports should be oiled on both sides with Tylö sauna
oil.
Note: All other wood in the sauna should be left untreated.
In the event of any problems, please contact the retailer where
you purchased the equipment.
© This publication may not be reproduced, in part or in whole, without the written permission of Tylö.
Tylö reserves the right to make changes in materials, construction and design.
5