Description - RIDGID PCS-500 Manual Del Usario

PCS-500 PipeSaw

description

The RIDGID ® Model PCS-500 Transportable Pipe Saw is
designed to clamp on the pipe and create a square cut.
The saw can cut steel, stainless steel, plastic and cast iron
pipes with the correct saw blade selection.
The clamps securely grip the work piece between clamp
wheels and then the PCS-500 Transportable Pipe Saw is
mounted on the clamp. The cut is formed by rotating the
saw around the stationary pipe.
LED indicator lights are supplied to give feedback on
proper cutting speed. LEDs are normally OFF and flash to
indicate that the pipe is being cut too quickly.
The PipeSaw is lightweight and compact for ease of
transport.
The saw is not designed to cut bars and plates. The pipe
saw and clamp must be used together. The PipeSaw is
only meant to be used with pipe on stands, and is not
designed for use with in-place pipe.
Warning
Label
Handle
Brush Cap
wrench
LED
Indicator
ON/OFF Saw
Light
(I/O)Switch Foot
Number Plate
Figure 1 – Model PCS-500 Transportable Pipe Saw, Front
Side
Blade Change
Label
Saw Blade
Cover
Saw Blade
Cover Door
Latch
Pivot
Grip
Blade
LED Indicator
Bolt/Clutch
Light
Figure 2 – Model PCS-500 Transportable Pipe Saw, Back
Side
6
Cord
Cord
Wrap
Gear Box
Gear Box
Temperature
Warning
Chip Chute
Warning
Label
Pivot Pin
Hex
Bore
Saw
GFCI Cord
Serial
Foot
Cord Clip
Brush Cap
Cut Position
Hole
Plunge
Plate
Saw Blade
Ready Position
Blade
Guards
Hole
Quick Release
Clamp
Lever
Handlebar
Clamp
Location
Decal
Upper Carriage
Plunge
Lock Pin
Plunge Plate
Clamp
Wheels
Figure 3 – RIDGID ® Clamp
Figure 4A – PipeSaw Clearance on Pipe - Axial
Figure 4B – PipeSaw Clearance on Pipe - Radial
Screw
Handle
Lead Screw
Pivot Pin
Guard Start
Bracket
Guide
Clamp
Wheels
Alignment
Pad
999-995-226.10_REV. A