Connection Of Communication Wire Between Indoor Unit And Outdoor Unit(Or Indoor Unit); Connection Of Communication Wire For Wired Controller - Gree GMV-ND22TD/A-T El Manual Del Propietario

L
N
For units with single-phase power supply.
1) Detach the electric box lid.
2) Let the power cord pass through the wiring through-holes.
3) Connect the power cord to terminal "L, N,
4) Fix the power card with wiring clamp.
5.3 Connection of Communication Wire between Indoor Unit and Outdoor
Unit(or indoor unit)
(1) Detach the electric box lid.
(2) Let the Communication cable pass through the wiring through-holes.
(3) Connect the communication wire to terminal D1 and D2 of indoor 4-bit wiring board, as shown
in fig 5.3.1.
wiring screw
(4) Fix the communication cable with clamp of electric box.
(5) For more reliable communication, make sure connect the terminal resistor to the most
downstream IDU of the communication bus (terminal D1 and D2), as shown in fig 5.3.2,
terminal resistor is provided with each ODU.

5.4 Connection of Communication Wire for Wired Controller

(1) Detach the electric box lid.
(2) Let the communication wire pass through the wiring through-holes.
(3) Connect the communication wire to terminal H1 and H2 of indoor 4-bit wiring board.
(4) Fix the communication wire with clamp.
(5) Wiring instructions of signal receiver and wired controller:
1) Wired controller (standard) is shown as Fig.5.4.1,wireless controller (optional) is shown as
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Multi Variable Air Conditioners One-way Cassette Type Indoor Unit
Fig 5.2
terminal board
Fig 5.3.1
15
".
indoor unit
previous IDU
IDU PCB
communication
interface CN12
D1 D2 H1 H2
1
H1 H2
D1 D2
match resistance
for communication
Fig 5.3.2