Revell Control FIRE TRUCK Manual Del Usuario página 7

4 START PREPARATION
To start, set the ON/OFF switch (1F) on
the underside of the model to "ON". The
remote control switches on automatically
when the control buttons are pressed.
The ON/OFF switch on the vehicle must
be set to "OFF" after use. If this is not
done, a drive command can be triggered
accidentally, causing the vehicle to drive
away on its own and potentially causing
serious damage.
6 VEHICLE CONTROL
6A To drive forwards, press the forward button (2A).
6B To reverse, press the reverse button (2B). The model stops immediately when the
button is released.
6C To follow a left-hand curve, press the 2C button.
6D To follow a right-hand curve, press the 2D button.
INSTRUCTIONS FOR SAFE DRIVING
GENERAL DRIVING TIPS:
• Always maintain visual contact with the vehicle and do not look at the remote
control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
• After a crash, always release the speed control immediately in order to prevent
damage to the electronics.
THE SUITABLE DRIVING ENVIRONMENT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
12
5 TRIM
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
If the vehicle pulls to the left or right
while driving without steering...
turn the trim (1C) to correct the wheel
alignment by turning it in the opposite
direction.
TROUBLESHOOTING
Problem: The vehicle does not move.
Cause:
• The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model
• Please replace with new batteries.
Problem: Remote control does not work.
Cause: 1. The batteries were not inserted correctly.
2. The batteries do not have enough power.
Remedy: 1. Check whether the batteries are inserted correctly.
2. Please replace with new batteries.
Problem: The vehicle cannot be controlled with the remote control.
Cause: 1. The batteries are depleted.
2. The connection between the remote control and vehicle has been severed.
Remedy: 1. Insert new batteries.
2. When the model is further than 10 metres away, move towards the model.
Additional tips and tricks can be found online at www.revell-control.de.
SERVICE NOTES
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13