nVent RAYCHEM E-100-A Instrucciones De Instalación página 5

E-100-A Re-entry Instructions
A
WARNING: Shock
Hazard. Conductors
will be exposed.
Re-entry should only
be performed by
qualified personnel.
Follow standard
electrical lockout
procedures before
opening end seal.
• Turn off power.
• Clip cable tie and remove.
C
CAUTION: Health Hazard.
Wash hands after contact
with sealant. Consult
material safety data
sheet VEN 0058.
• Grab black ring and remove boot.
E
• Inspect boot. If boot is damaged or sealant appears dry
or missing, replace boot. For replacement boots, order kit
E-100-BOOT-5/PACK. Otherwise, re-install boot.
B
• Unscrew cap from end seal stand.
D
• Test as required.
• Refer to Industrial Heat-Tracing Installation and
Maintenance Manual (H57274) for test procedures.
F
• Install cap; tighten until the slot on the cap and the slot
on the stand align.
• Install new cable tie.
Trim
nVent.com | 5