wissner-bosserhoff SafeSense Manual De Instrucciones página 39

foot side
Duomat 9
Fasten the box to the motor under the backrest at the head end of the bed!
Insert the nurse call cable in the bed's cable conduit and fasten it to the strain relief fixture
with a cable tie. Reconnect the power plug.
Scan this QR code to see the step-by-step
installation video:
Open the fastening clip of the motor and
slightly pull out the slider. Attach the box to
the motor by inserting the holding tab from
below, hook the upper holding tabs into the
slider and put it in the initial position. Close
the fastening clip.
Then, put the protective cap back onto the
motor.
head side
Plug the handset and sensor
mat into the bed exit box (the
handset on the left, the sensor
mat on the right). Attach the
strain relief for the handset
cable.
39