Installing On A Nursing Home Bed With Motor „Quadromat 7" And Battery - wissner-bosserhoff SafeSense Manual De Instrucciones

The final step is to connect the SafeSense
version, this is done by connecting the plug on the SafeSense
call system.
6.4 Installing on a nursing home bed with motor „Quadromat 7"
and battery
Connect the Bed-Exit box to the bed drive. To do this,
plug the connector plug (on the left of the box) into the
now empty slot on the drive.
Insert the sensor mat into the Bed-Exit Box. To do this,
first remove the plug of the connection socket below
the dial for call interval setting. Then position the sen-
sor mat as described in chapter 6.6. Reconnect the
power plug.
system to your nurse call system. For the cable
®
1. Remove the battery pack from the bed
and remove the two diagonally opposite
screws.
2. Attach the retaining plate to the bed exit
box. (The holding tabs should be on the
sides)
For the wireless version (see
photo), please plug the wireless
receiver's power supply into a
power socket and connect the
plug to your call system. The
wireless receiver must then be
calibrated to the SafeSense
system.
system to the socket on your
®
®
41