Rear Panel - Fender TONE MASTER Super Reverb-Amp Manual De Instrucciones

IEC INLET: Connect included power cord to a grounded
P.
outlet in accordance with the input power voltage and
frequency beside inlet. Universal 100V-240V operation.
POWER: Turns amplifier on and off.
Q.
MUTE: Mutes power amp. When in MUTE mode, XLR line
R.
output remains active for studio or "quiet stage" use, and
POWER JEWEL (O) illumination changes from red to amber.
OUTPUT POWER: Selector switch offers full power (45
S.
watts) and five other attenuated wattage settings that tailor
room/venue overall loudness. Set amp front-panel channel
volume to personal preference for tube-emulated response,
then set OUTPUT POWER to preferred level.
CABINET SIM: When using XLR BALANCED LINE OUTPUT
T.
(W), this switch offers three different tonal options—a flat,
uncolored amp signal without speaker cabinet emulation
(OFF); and two impulse response (IR) profiles emulating
different speaker/ microphone-placement combinations:
IR PROFILE 1: Dynamic microphone close-mic'ed at edge
of speaker cone center cap for pronounced attack and
definition. IR created using a Shure® SM57 microphone.
IR PROFILE 2: Ribbon mic, close-mic'ed for increased
smoothness and bass response. IR created using a Royer
Labs® R-121 Studio Ribbon microphone.
BALANCED LINE OUTPUT LEVEL: Adjusts output level of
U.
TYPE
POWER REQUIREMENTS
POWER AMP OUTPUT
INPUT IMPEDANCES
XLR LINE OUT IMPEDANCE
SPEAKER
FOOTSWITCH
COVER
DIMENSIONS AND WEIGHT

REAR PANEL

For questions and troubleshooting,
contact a Fender specialist at:
1-800-856-9801 (U.S. toll free)
1-480-596-7195 (International)
SPECIFICATIONS
PR 5966
450 watts (max)
200 watts (simulates 45W tube amp performance)
Input 1 (both channels): 1MΩ
600Ω
Four 10" Jensen® P10R, 8Ω (PN 0055613000)
Two-button Tone Master (included, PN 7716005000)
Included (PN 0041533000)
Width: 25.12" (63.5 cm) Height: 24.75" (63 cm)
Product specifications subject to change without notice.
XLR BALANCED LINE OUTPUT (W) for external devices and
systems (i.e., PA and recording gear), whether mic or line level.
GROUND LIFT: When using the XLR BALANCED LINE
V.
OUTPUT (W), engaging this button may eliminate hum or
buzz resulting from connection to improperly grounded
equipment.
XLR BALANCED LINE OUTPUT: For balanced connection
W.
to external devices and systems (i.e., PA and recording
gear). XLR line output remains active when amp is in
MUTE mode (R).
FOOTSWITCH: Connect included two-button footswitch
X.
for reverb and tremolo on/off here.
USB PORT (NOT SHOWN): For firmware updates, a USB
Y.
port is located on the underside of the chassis beneath
the OUTPUT POWER section. Visit fender.com/firmware/
support for periodic firmware updates that improve and
enhance the Tone Master experience.
All non-FMIC product names and trademarks appearing in this
manual are the property of their respective owners and are used
solely to identify the products whose sounds were studied during
IR development for this product. The use of these products and
trademarks does not imply any affiliation, connection, sponsor-
ship, or approval between FMIC and with or by any third party.
Input 2 (both channels): 136kΩ
Depth: 10.5" (26.5 cm)
2
Weight: 36 lbs. (16.3 kg)