Honeywell Miller Instrucciones De Uso página 39

SAFETY INSTRUCTIONS
BEFORE USING: • Check lifeline retraction--Pull out a min. 4ft. (1.2m) of lifeline
and allow to retract under light tension. • Check braking action--Grasp lifeline
ABOVE load indicator and apply a sharp pull. The brake must engage. Release
tension and allow lifeline to retract slowly into unit. Lifeline must retract
completely. • Inspect webbing load indicator. If warning flag is exposed,
remove from service. INSTALLATION: • See instructions for mounting
procedure. • Anchorage and mounting hardware must be capable of
supporting a 5,000lb. (22kN) static load or meet OSHA requirements for a
safety factor of two. • Anchor device vertically overhead whenever possible;
for suitability in other installation applications (i.e., lift, horizontal use/lifeline),
refer to instructions.
INSPECTION GRID
YR J
F M A M J
1
2
3
4
5
A S O N D
J
39