Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.1 Programming Mode Parameter List
Temperature Unit Selection Parameter ( Default = 0 )
°C selected.
°F selected.
Decimal Seperator Enabling Parameter
None.
Only Temperature parameters with decimal seperator.
Only Humidity parameters with decimal seperator.
Only Temperature and Humidity parameters with decimal seperator.
Note : When value of
,
,
,
should be changed accordingly.
Note :
,
and
( 0/2..10V or 0/4..20mA ) is selected.
Temperature Sensor Scale Selection Parameter ( Default = 0 )
Analogue (T
0..10V
2..10V
Temperature
It can be adjusted from -1999 to (
If
If
Temperature
It can be adjusted from (
According to the device type10V
Note :
,
parameters are shown, if the Temperature sensor analogue input type is selected .
Temperature Control Selection Parameter On/Off or PID ( Default = 0 )
On - Off selected.
PID selected.
Note: If this parameter is select 0, PID parameters (
If this parameter select 1,
Auto Tune (Limit Cycle Tuning)
Device does not do(Limit cycle Tuning) operation.
Device does operation.
PID - Proportional Control Parameter
This parameter value can be adjusted form 0 to 100.
PID - Integral
This parameter value can be adjusted form 0 to 3600.
PID - Derivative Parameter
This parameter value can be adjusted form 0 to 3600.
PID -Period Time Parameter
This parameter value can be adjusted form 1 to 50 second.
(1)
It is valid, if the device type 0/2...10V
i
(2)
It is valid, if the device type 0/4...20mA
or
parameters are changed , the values of
,
,
,
,
parameters are shown, if the Temperature sensor
emperature)
input range is determined with this parameter.
(1)
Z
veya 0..20mA
(1)
Z
veya 4..20mA
Sensor Scale Low Limit Parameter : ( Default = 0 )
=0, according to the device type 0V
=1, according to the device type 2V
Sensor Scale High Limit Parameter : ( Default = 100 )
+1) to 9999. At this value analogue input becomes;
(1)
Z
parameter will be not observed.
Selection Parameter ( Default =
Parameter( Default = 1000 )
( Default = 250 )
( Default = 1 )
( Default = 0 )
,
,
,
,
(2)
Z
(2)
Z
-1). At this value analogue input becomes;
(1)
Z
Z
or
0mA
(1)
Z
Z
or
4mA
(2)
Z
or
20mA
,
,
,
( Default =50 )
Z
Temperature
Z
Temperature
,
,
,
,
and
parameters
analogue
input type
(2)
(2)
,
) will be not observed.
)
Sensor Input.
Sensor Input
.
,
9
Publicidad
Tabla de contenido
