Harbor Breeze LP8221LCH Manual Del Usuario página 10

OPERATING INSTRUCTIONS
3. To make fan operational, install 12-volt battery
(included in remote control package) into the
remote (C).
CAUTION
If you are not expecting to use the remote for a
long period of time, remove the battery to
prevent damage to the remote. Be sure to store
the remote away from excess heat or humidity.
4. Follow the below steps to set the remote (C):
1) When powering on your fan, do not press
any button(s) before pressing the "SET"
button, otherwise it will fail the learn
procedure. If you press a button before the
"Set" button, please turn the power off then
on again, and start the process again.
2) Set the dip switches inside the battery
compartment door of the hand held
transmitter to the desired setting.
3) After installing the unit and restoring
power to your fan, press and hold the "SET"
button 1~5 seconds. You must press the
"SET" button within 60 seconds of restoring
power to the fan.
4) The fan will start to run and begin the
control setting process.
5) DO NOT press any button(s) after
pressing the SET button and while the fan is
programming or it will fail to program. The
fan will run in both directions for a total of
approximately 5 minutes.
6) When the fan stops after approximately 5
minutes the control and speed setting
process is complete.
The fan is now ready for normal use.
NOTE
If you want to change the blades: turn
the off→ change the blades →turn the
power on →replay the power setting process.
3
4
10
Lowes.com/harborbreeze
C