Saivod SAP718 Manual Del Usuario página 102

Installation in a sliding sash window(Optional)
1. Connect the rain guards to the insect guard net.
Insert all three projections on each rain guard into the holes in the insect guard net.
Side "A" will now be at the top, as indicated in the diagram.
2. Attach the guard combined above to the window panel.
Push the insect guard net firmly to ensure that its four projections fit into the holes
in the window panel.
Side "A" will now be at the top, as indicated in the diagram, when it is installed in
the window.
3. Cut the Foam seal B (adhesive type) to the proper length and attach it to the
window frame and to the side of sash.
4. Install the window panel into the window frame.
Make sure that the exhaust cover is attached to the window panel.
Inner height of the window:20.5"(520mm)
Use the window panel.
Insect guard net
Hole
Projection
Projection
"A"
Rain guard
Window panel
"A"
Foam seal B (adhesive type)