Saivod SAP718 Manual Del Usuario página 83

Operation Introduction for Control Panel
3
Mode button
Press this button and the mode will circulate according to below sequence:
COOL→DRY→FAN
COOL: Under this mode, cooling mode indicator is bright. Dual-8 nixie tube displays
set temperature. Temperature setting range is 16°C~30°C.
DRY: Under this mode, drying mode indicator is bright. Dual-8 nixie tube won't
display.
FAN: Under this mode, the air conditioner only blow fan. Fan indicator is bright.
Dual-8 nixie tube won't display.
4
Fan button
Press this button and the fan speed will circulate as "low speed→ medium speed →
high speed→ auto fan→ low speed".
5
Timer
Press timer button to enter into timer setting mode. Under this mode, press "
-
or " " button to adjust the timer setting. Timer setting will increase or decrease
0.5 hour by pressing "
increase or decrease 1 hour by pressing "
After timer setting is finished, the unit will display temperature if there's no
operation for 5s. If timer function is started up, the upper indicator will keep the
display status. Others, it won't be displayed. Under timer mode, press timer button
again to cancel timer mode.
6
Sleep
Press sleep button to enter into sleep mode. If the controller operates at cooling
mode, after sleep mode is started up, preset temperature will increase by 1°C
within 1 hour ;preset temperature will increase by 2°C within 2 hours and then the
unit will operate at this temperature all the time; Sleep function is not available for
fan mode, drying mode. If sleep function is started up, the upper indicator will keep
the display status. Others, it won't be displayed.
-
+
" or " " button within 10 hours, while timer setting will
-
+ " or " " button beyond 10 hours.
+ "
GB