Kohler STERLING 6300 Serie Guia De Instalacion página 11

Strike
Jamb Latch
#6-20 x 1/2"
Screw
7. Install the Strike Jamb and Strike Seal
Position the latch in the strike jamb.
Using the 5/64" hex wrench provided, tighten the two screws to secure the latch in place.
Repeat with the second latch.
Push the strike jamb into the appropriate wall jamb with the wide lip facing toward the inside of
the shower. Each slot in the strike jamb will slide over the screw body and fit between the clamp
and wall jamb.
Secure the strike jamb to the wall jamb at the top and bottom by tightening the flathead screws with
the 3/32" hex wrench until snug.
Install a strike jamb cover on the top opening of the strike jamb.
Slide the strike seal strip into the T-slot of the strike jamb until the seal touches the bottom track.
With a utility knife, trim the excess seal so the seal is flush with the top of the strike jamb.
Sterling
Wall Jamb
Strike Jamb
11
Bottom View
Strike Jamb Cover
Wall Jamb
Strike Seal
Strike Jamb
Flathead Screw
Top View
Adjustment Clamp
1019156-2-H