Kohler STERLING 6300 Serie Guia De Instalacion página 5

Adjustment Clamp
Note: Do not fully
tighten screw.
2. Install the Adjustment Clamps
Insert four adjustment clamps into each wall jamb (eight total).
Partially thread a #8-18 x 3/4" flathead screw through the pre-drilled holes in the wall jambs and
into each adjustment clamp using the 3/32" hex wrench provided. Do not fully tighten the screws at
this time to allow strike jamb and hinge jamb installation.
Sterling
#8-18 x 3/4"
Screw
Wall Jamb
Top View
Flathead
Screw
Wall
Jamb
5
Top View
Adjustment
Clamp
Wall Jamb
1019156-2-H