Electrical Connections - Riello PRESS 300 T/N Instrucciones De Instalación, Montaje Y Funcionamiento

3.3 ELECTRICAL CONNECTIONS TO THE BURNER TERMINAL STRIP
H Remote lock-out signal
IN Optional switch on-off burner
MB Burner terminal strip
PS Reset push - button
SA High temperature oil alarm
NOTE:
Check the lock-out by darkening the photo-cell after removal of the cover.
❱
ATTENTION HIGH VOLTAGE.
In case of supply 230V without neutral, connect the motor and the pre-heater thank through delta (the "star"
❱
connection is the original one, made for 400V).
NOTE
❱
In systems where the run of wiring connecting the thermostat exceeds 20 metres in length, or in places where
the burner is subject to particularly disturbing electromagnetic interference (over 10 v/m), you must insert the
relay-interface kit item number 3010386.
5844
DIRECT START-UP
(to be carried out by the installer)
TL Limit control device system
TS Safety control device system
T2 Load control system for 2
Load control system for 3
T3
9 GB
D2619
230V 400V
A A gG/gL 63 50
B A gG/gL 63 50
2
C mm 6 4
2
D mm 10 6
nd
stage
rd
stage