Manitowoc LB Manual De Instalacion, Operacion Y Instalacion página 5

Section 1
Accessories
K00499 48" Paddle
K00503 60" Paddle
K00500 37" Shovel
Using the Ice Paddle Accessory
Ice paddle is an optional accessory. If your bin has been
ordered with ice paddle, mount the paddle for easy access
on either side of bin.
If there is adequate ice in bin but lower door area is not filled
with ice, it may be that ice has congealed and will not flow.
This can often be remedied by quickly raising/lowering the
baffle several times (see preceding, Baffle Operation). If the
problem continues, the ice paddle can be used to break up
the congealed ice mass
n
Use the ice paddle only as described above. To avoid
possible injury, keep head and face clear of lower door
area and tool at all times. Do not use probe tool for other
purposes.
Cleaning Exterior of Bin
Exterior stainless steel surfaces can be cleaned with a mild
soap and water solution or a stainless steel cleaner and
polish.
Part Number: 000016538 Rev01 02/21
Warning
Cleaning and Sanitizing Bin Interior
Interior of bin must be cleaned and sanitized prior to use and
must be cleaned on a routine basis during use.
Ice storage bins must be descaled and sanitized every six
months with Manitowoc Ice Machine Cleaner and Sanitizer.
,
Use only Manitowoc approved Ice Machine Cleaner/
Descaler and Sanitizer for this application (Manitowoc
Cleaner/Descaler part number 9405463 and Manitowoc
Sanitizer part number 9405653). It is a violation of Federal
law to use these solutions in a manner inconsistent with
their labeling. Read and understand all labels printed on
bottles before use.
n
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or Sanitizer.
1. Remove upper inspection windows by sliding windows
to one side. Grasp the end of the front window and pull
toward you as the window is slid to the opposite side.
Repeat for rear window.
2. Mix a solution of cleaner/descaler and warm water.
Depending upon the amount of mineral buildup, a larger
quantity of solution may be required. Use the ratio in
the table below to mix enough solution to thoroughly
descale all parts.
Solution Type
Descaler
3. Wash bin walls, hopper, access door and rinse all areas
thoroughly with clean water.


Important
Do not rinse after sanitizing
4. Mix a solution of sanitizer and warm water.
Solution Type
Sanitizer 3 gal. (11 L)
5. Sanitize bin walls, hopper and access door plate. Use a
spray bottle to liberally apply the solution. Do not rinse
the sanitized areas.
Installation Operation Maintenance
Caution
Warning
Water Mixed With
1 gal. (4 L) 16 oz. (500 ml)
cleaner/descaler
Water Mixed With
2 oz. (60 ml)
sanitizer
5