Sold Separately; Before You Start; Back-To-Back Installation; Installation Instructions - American Standard Cadet 2794.709 Instrucciones De Instalación

Wax Ring
BEFORE YOU START: Please see specificaton sheet for rough-in information
Turn Off Water Supply
Recommended fitting type for
back-to-back installations.

INSTALLATION INSTRUCTIONS:

1
NOTE: T Bolts with retainer included.

SOLD SEPARATELY

Water Supply Line
If Removing An Existing Toilet
Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.
Depending upon your plumbing and venting conditions, the flow from the
toilet in a back-to-back installation may create a vacuum on the system
and draw water from the opposing bowl. The National Standards Plumbing
Code prohibits the use of a cross fitting for drainage as throw over is
possible. The code does approve a directional "Y" style fitting with proper
venting to direct the water downward and away from the other toilet.
- 2 -
Clean Flange

BACK-TO-BACK INSTALLATION

2
Press firmly.
NOTE: Bowl with exposed trapway shown.
Slow Close Toilet Seat
(3517A bowl only)
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
Wax Ring
(sold separately)
7302484-100R1 10/20