American Standard Cadet 2794.709 Instrucciones De Instalación página 3

3
TIP: Place 2 pieces of masking tape on floor
(as shown) to help with alignment in step 4.
NOTE: If installing a Concealed Trap Toilet Bowl,
connect supply hose to supply valve.
5
Hand tighten only.
!
Do not overtighten.
NOTE: Exposed trap shown.
Bolt caps not used for
Concealed Trap models.
7
Thread, then hand
tighten water supply. This
is best done when using
Concealed Trap Bowl.
WARNING: Overtightening of water supply line nuts could result in breakage and potential flooding. If the
!
connection leaks after hand tightening, replace the supply line. Do not use any type of sealant on the water
supply connection. Use of plumber's putty, pipe dope, or any other type of sealant will void the warranty.
4
Apply weight evenly.
Do not move after
placement. Water
tight seal may break.
NOTE: Bowl with exposed
trapway shown.
6
MANUAL FLUSH
BUTTON
8
Tighten handles
alternately until tank
contacts bowl.
HAND TIGHTEN
ONLY!
* For seat installation,
see instructions
included with seat.
- 3 -
7302484-100R1 10/20