How To Clean; Product - Coway airmega AP-1220B Manual Del Usuario

HOW TO CLEAN

- Always unplug the power cord before cleaning.
- Do not use organic solvents (thinner, etc.), bleach, or detergents containing chlorine
or abrasives to clean the product.
Tips
- Do not immerse the product in water or spray water on it.
■ How to Clean Pollution Sensor
(every two months)
1. Open the pollution sensor cover on the
left side of the product. Clean the air
inlet, outlet, and the pollution sensor
area with a soft brush or a vacuum
cleaner first.
2. Wipe the lens and the dust inlet and outlet with a moistened cotton
swab, and wipe them again with a dry swab to remove moisture.
∗
Failure to clean regularly may result in reduced performance of the
pollution sensor.
∗
Clean the sensor more frequently in a dusty environment because
the cleaning cycle varies depending on the operating environment.
■ How to Clean Air Inlet and Outlet (every two months)
Clean the air inlet and outlet with a soft brush.
∗
Take care not to allow dust to fall inside the product when cleaning.
■ How to Clean Front Cover
Remove the front cover from the product and remove dust from
the surface of the cover with a soft, dry cloth or a soft brush.
∗
If the degree of pollution severe, use a slightly wet cloth to wipe it.
(Do not use an abrasive.)
■ How to Clean Main Body of Product
(every two to four weeks)
Use a dry and soft cloth to wipe it.
∗
If the degree of pollution is severe, use a slightly wet cloth to wipe it.
(Do not use an abrasive.)
Vent
▶
Air inlet
Dust outlet
Dust
inlet