Replacing The Steering Pcb And/Or Fuse - NAMCO WANGAN MIDNIGHT Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
8-3

Replacing the Steering PCB and/or Fuse

1.
Remove 8off button head screws (M5x12) and remove the Monitor Cabinet
Rear Cover.
2.
Replace the fuse or:
3.
Disconnect the six connectors shown shaded in the diagram below.
4.
Loosen 2off pozi head screws (M6), lift the PCB Base to disengage it from the
screws and remove the PCB with the PCB Base.
5.
Remove 4off pozi head screws (M3x12), with flat and spring washers, and
remove the Steering PCB.
2P side
(The 1P fuse is on the
other side of the panel.)
Fuse
6.
Reassemble in reverse order.
Note:
When refitting the PC Base ensure that the tab at the bottom of the PC Base
engages in the slot in the cabinet.
Steering PC board
(+)Phillips pan head screw (with flat/spring washer) (M3 x 12)
Page 65
Countersunk nut (M6)
Connector
PCB base

Publicidad

Tabla de contenido
loading

Tabla de contenido