Replacing The Solenoid And Fluorescent Lamp Fuse; Replacing The Hammer - NAMCO SPIN THE SPIN Manual Del Operador

7-3 Replacing the Solenoid and Fluorescent Lamp Fuse

The fuse holder is of the type where the end caps of the fuse are inserted
between clasps. To remove the fuse, gently prise out using a small screwdriver
or similar tool.
To install a fuse, place the fuse end caps on the clasps and press both ends of
the fuse into the clasps with equal force.
(Use a 1¼" 250v 1A Q/B fuse)

7-4 Replacing the Hammer

1. Remove the security screw (M4x25) and 2 flat washers (M4) from the end
of the grip.
2. Ensure that the ring of the rope is between the 2 flat washers and fit to
the end of the grip with the security screw (M5x25).
3. Pull on the wire rope to ensure that it is fastened securely.
Page 42