Replacing The Sub Shaft And Sub Shaft Rubber - NAMCO SPIN THE SPIN Manual Del Operador

7-13-4 Replacing the Sub Shaft and Sub Shaft Rubber.

1. Remove the front glass.
2. Remove the front table.
3. Remove the 4 socket cap screws (M5x16), flat and spring washers
that hold the sub shaft frame in place, and remove the sub shaft
frame.
4. Remove the sub shaft rubber by unscrewing it from the sub shaft.
5. Fit the new sub shaft rubber by screwing it in to the sub shaft.
6. Reassemble in reverse order.
Ensure that the target is central in the bezel when reassembling.
(see section 7-6 "Replacing the Ball")
(see section 7-5 "Replacing the Wire Rope")
Page 53